We have several tower locations on which radio access points are installed.  Once a site survey has been done at your home or place of business, we will install the necessary client radio at the location.  Client radios vary in antenna size and transmit power.  We will know the antenna size required after your site survey is completed.  The client radio is installed on the outside of the location at the point that will receive the best signal.  This is done using either a DSS swing arm attached to a point on the building, on an existing TV tower, or on a pole set in the ground.  (Customers are responsible for any towers or poles being installed prior to installation appointment).  A cat 5 cable is ran from the client radio to the inside of the building to where your computer or router is located.  The cable is attached first to a power injector that provides power to the client radio.  Another cable is then ran from the data side of the power injector to your computer or router.  Networking to additional computers can be done for additional cost.